Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Unitary Duct Split Unitary Duct Split
Ⅱ Installation Location and Matters Needing Attention
The installation of the unit must comply with the national and local safety
regulations. The installation quality directly affects the normal use, so the user
should not carry out the installation personally. Instead, the installation and
debugging should be done by the professional personnel. Only after that, can the
unit be energized.
1How to select the installation location for the indoor
unit
a. Where there is no direct sunlight.
b. Where the top hanger, ceiling and the building structure are strong enough to
withstand the weight of the unit.
c. Where the drain pipe can be easily connected to outside.
d. Where the flow of the air inlet and outlet are not blocked.
e. Where the refrigerant pipe of the indoor unit can be easily led to outside.
f. Where there is no inflammable, explosive substances or their leakage.
g. Where there is no corrosive gas, heavy dust, salt mist, smog or moisture.
CUATION！
The unit which is installed in the following places is likely to run abnormally. If
unavoidable, please contact the professional personnel at the GREE appointed service
center：
① Where is full of oil;
② Alkaline soil off the sea;
③ Where there is sulfur gas(like sulfur hot spring);
④ Where there are devices with high frequency (like wireless devices, electric
welding devices, or medical equipments);
⑤ Special circumstances.
3
Publicité
Chapitres
Table des Matières
