Pellet Specifications; Corn Specifications - Napoleon TIMBERWOLF TPS35 Instructions D'installation Et D'opération

2.4.2 PELLET SPECIFICATIONS

IT IS IMPORTANT TO SELECT AND USE ONLY PELLETS THAT ARE DRY AND FREE OF DIRT
OR ANY IMPURITIES SUCH AS HIGH SALT CONTENT. DIRTY FUEL WILL ADVERSELY AFFECT
THE OPERATION AND PERFORMANCE OF THE APPLIANCE AND WILL VOID THE WARRANTY.
THE PELLET FUEL INSTITUTE (P.F.I.) HAS ESTABLISHED STANDARDS FOR WOOD PELLET
MANUFACTURERS. WE RECOMMEND THE USE OF PELLETS THAT MEET OR EXCEED THESE
STANDARDS. ASK YOUR DEALER FOR A RECOMMENDED PELLET TYPE.
Pellet quality is important, please read the following:
Your Wolf Steel Ltd. Pellet Appliance has been designed to burn premium hard or soft wood pellets only. Do
not use any other type of fuel such as fi re logs or fi re starting pellets, as this will void the warranties stated in
this manual.
The performance and heat output of the pellet appliance is directly related to the quality and moisture of the
pellets. Store pellets in a cool dry area to prevent moisture absorption.
P.F.I. PELLET STANDARDS:
Inorganic Fines (fi ne
particles)
Bulk Density
Size
Ash Content
Moisture Content
Chlorides
Trace Metals
Heat Content
Construction Waste

2.4.3 CORN SPECIFICATIONS

Use only clean-shelled corn with a moisture content less than 15% and approximate fuel value of 7,000 BTU/
lb (16,200 kJ/kg). Do not attempt to burn corn with higher moisture content or burn lesser grade fuels. Do not
burn other types of agricultural pellets or by-products (alfalfa, cherry pits, olive pits, nut shells, etc.) as they
are not permitted to be burned in this appliance.
Corn must be clean and free of debris. Never burn corn right from the fi eld. Damage caused by dirty corn is
not covered by the Lifetime Limited Warranty. Ask for screened corn only. Stalk parts, excessive fi nes and
cob remnants will clog the air fl ow holes in the burn plate. Check the corn for foreign objects.
Use only a maximum 50% corn to pellet mixture.
!
1% maximum through a 1/8" (3.2mm) screen
38 pound per cubic foot minimum
1/4" (6.4mm) to 5/16" (8mm) diameter, 1/2" - 1 1/2" (13mm
- 38mm) long maximum
No more than 2%
8% maximum
300 parts per million by weight
Less than 100mg/kg
Approximately 8200 BTU/Hr per pound minimum
Not to contain any waste materials
WARNING
64.1
If the fuel does not comply to
this standard the appliance
may not operate as designed.
We recommend the use of
premium grade (1% ash
content) for longer appliance
life and less frequent cleaning.
W415-1477 / A / 10.19.16
9
EN