Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
32
8.7
THERMOSTAT INSTALLATION
An optional millivolt thermostat is available to help keep the room temperature constant.
EN
NOTE: The thermostat must be installed by a qualifi ed installer.
•
Disconnect the power supply.
•
Remove the right side panel to gain access to the rear of the control panel.
•
Strip and connect the two thermostat wires to the two screw terminals on the back of the control
panel.
NOTE: The control must be in AUTO to control the appliance with a thermostat.
8.8
SHUTDOWN INSTRUCTIONS
Slide the "ON/OFF" button to "OFF". Your appliance will cycle down and the blower will remain operating until
your appliance has cooled.
9.0 NORMAL OPERATING SOUNDS
EXHAUST BLOWER
The flow of exhaust gases may
create a low-pitched hum. As
the pellet feed rate is altered
this sound will change.
AUGER MOTOR
An irregular buzz of the motor
running might be heard when
pellets are being fed.
Expansion / contraction noises during heating up and cooling down cycles are normal and are to be expected.
W415-1477 / A / 10.19.16
CONVECTION BLOWER
A low hum might be heard due to the high
efficiency fan, especially on high.
BURN POT
A light clicking sound
might be heard as the
pellets are fed into
the burn pot.
Publicité
Chapitres
Table des Matières
