Napoleon TIMBERWOLF TPS35 Instructions D'installation Et D'opération page 35

10.1.6 BURN POT CLEANING
MAKE CERTAIN THE HEATER HAS FULLY COOLED (APPROXIMATELY 25 MINUTES) BEFORE
To clean the burn pot, open the door and knock away any debris on the
burn pot. If severely clogged, remove the burn pot to gain better access.
If removing the burn pot set aside on a non-combustible surface. Once
removed, discard all material that has accumulated in the burn pot.
Make certain that all openings are clear of any build up of ash from the
ledge below the burn pot.
Re-install the burn pot ensuring it sits level in the
appliance. Also must ensure the ignitor and the burn
pot locating notch line up when reinstalling the burn
pot.
NOTE: Fuel and ash build up along with a lazy dark
orange fl ame may indicate that openings in the
burn pot are blocked.
10.2 BI-WEEKLY (OR EVERY 10 BAGS OF PELLETS)
10.2.1 VACUUM FIREBOX
THE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOL COM-
The more frequently you clean out the fl y ash, the more effi cient your appliance
will burn.
A. Open the viewing door.
B. Lift the burn pot out and set aside on a non-combustible
surface.
C. Vacuum out the fi rebox. Do not use a household
vacuum to clean the appliance. We recommend that
you use a shop vacuum that is equipped with a fi ne dust fi lter or
a vacuum specifi cally made for ashes and soot. Using a vacuum
which is not equipped with a fi ne dust fi lter may clog and disperse
fl y ash and soot into the room. NOTE: The appliance must be
completely extinguished before you vacuum the appliance.
Burning pellets, if sucked into the vacuum will light the
vacuum on fi re and may ultimately cause a house fi re.
Re-install the burn pot ensuring it sits level in the appliance. Also must ensure the ignitor and the burn pot
locating notch line up when reinstalling the burn pot.
WARNING
!
OPENING THE DOOR AND CONDUCTING SERVICE.
WARNING
!
PLETELY BEFORE CONDUCTING SERVICE.
NEVER VACUUM HOT EMBERS.
LOCATING
NOTCH
IGNITOR
40.6A
FIREBOX
AIR
HOUSING
40.18
35
EN
W415-1477 / A / 10.19.16