Appliance Description; Before First Use; Preparing Milk Foam; Heating Milk - Inventum MK460 Mode D'emploi

2

appliance description

1. Lid with sealing ring
2. Silicone cuff
3. Start button for heating and frothing
4.Start button for just frothing
5. Base
6. Maximum indication for heating milk - MAX
7. Maximum indication for frothing milk - MAX
8. Whisk (frothing)
9. Mixer (heating)
6
7
8
3

before first use

Before you use the appliance for the first time, please do
as follows: Carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and
cardboard) out of reach of children. Check the appliance after
unpacking for any visible damage, possible from transportation.
Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy
water. Dry the parts thoroughly. Make sure that the parts are
completely dry.
Wipe the exterior and interior with a soft damp cloth and dry
thoroughly. The appliance is only suitable heating and frothing
milk. Never fill the appliance with other drinks.
4

preparing milk foam

Check that the voltage in your home corresponds with the
voltage printed on the bottom of the appliance and plug
the appliance in.
Lift the lid and fit the whisk in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the lower max.
mark - MAX - 80 ml. Frothed milk expands and causes the
pitcher to overflow, if filled up too high. The minimum capacity
is 50 ml.
Put the lid back on the jug and place the appliance on the
base. Start the preparation by pushing one of the buttons
- heating and frothing or
burn and the whisk will start turning. Depending on the filling
volume, the preparation stops automatically after 65 to 90
seconds. The control light goes out. After the preparation is
completed, remove the lid upwards and pour or ladle the milk
foam into a cup or bowl.
Do not remove the foam with a spoon or other metal object.
10
• English
9
- just frothing. The control light will
This will damage the coating.
After having used the frother, clean the appliance as described
in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
TIPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good -
less than 50 ml.
5

heating milk

Lift the lid and fit the mixer in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the top max.
mark - MAX - 200 ml.
Put the lid back on the jug and place the appliance on the base.
Start the preparation by pushing the start button
control light will burn and the mixer will start turning. Depending
on the filling volume, the preparation stops automatically after
120 to 140 seconds. The control light goes out.
After the preparation is completed, remove the lid upwards and
pour the hot milk into a cup.After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
1
2
3
4
5
. The