Abicor Binzel MF1 Mode D'emploi page 32

7 Operation
7 Operation
EN - 14
1 Connect cable assembly to interface (3) and take out protection cap
toward the top. Connect control leads to master feeder MF1/2.
2 Rotate eccentric bolt (1) and take it out toward the top.
3 Open pressure rocker (5).
4 Press Inching trigger (4) until wire becomes visible.
5 Introduce wire into wire guide (2) and feed it through the wire guide (2) by
pressing the Inching trigger (4).
6 Close the pressure rocker (5) and insert eccentric bolt (1).
7 Press Inching trigger (4) until wire emerges from torch neck.
DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
During the welding of work-pieces that have been degreased with chlorine-
containing solvents phosgene gas is formed.
• Do not inhale fumes and vapours.
• Ensure sufficient supply of fresh air.
• Rinse work-pieces with clear water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
NOTE
• The master feeder MF1/2 may only be operated by skilled personnel.
• As the master feeder MF1/2 is integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and power supply, must be observed during operation.
1 Switch on the robot control.
MF1/2