SICK IN4000 Direct Serie Notice D'instructions page 58

en
Chapter 2

WARNING
58
On safety
Change notice
• For devices up to CW24 2018 the following
applies:
PFH 2.5 × 10
D
• For devices from CW25 2018 the following
applies:
PFH 1.0 × 10
D
⋅ Check whether the device complies with the
necessary safety requirements for the application.
Note on the classification of the device according to
EN 60 947-5-2:
• The IN40-E0101K safety switch complies with the
classification I1C40SP2M or I2C40SP2M depending
on the installation.
• The IN40-E0109K safety switch complies with the
classification I1C40SP2M or I2C40SP2M depending
on the installation.
Safety switches are not allowed to be bypassed,
turned away, removed or made ineffective in any
other manner. The outputs must not be bridged.
The inductive safety switches react to metal objects.
It must be ensured that it is not possible to place
other metal objects that are not intended to trigger
the safety function on the sensing face of the safety
switches. Suitable measures must be taken to
prevent this situation arising.
Please observe the installation features as per
EN ISO 14 119.
Damaged devices must be replaced.
© SICK AG • Germany • All rights reserved
–9
/category 4 (EN ISO 13 849-1)
–8
/category 3 (EN ISO 13 849-1)
Operating instructions
IN4000 Direct
8012183/ZWH0/2018-06-05
Subject to change without notice