Table des Matières
Publicité
30
· Remove the left side body panel of the tire changer by unscrewing
the four fixing screws.
· Remove the drive belt by means of the special adjusting screw X on
the motor support (Fig. 16). Before any operation disconnect the
electric power supplies.
· If necessary to adjust the vertical arm locking plate because the tool
does not lock or it does not rise from the rim of 2mm necessary for
working, adjust nuts as shown in Fig. 17.
For cleaning or replacing the silencer for opening/closing clamps, see
Fig 18 and proceed as follows:
1. Remove the left side panel of the machine body by unscrewing the
four fixing screws.
2. Unscrewing the silencer put on the pedal system, on the clamp ope-
ning/closing pedal.
3. Clean by a jet of compressed air or, if damaged, replace by referring
to the spare parts catalogue.
For cleaning or replacing the silencer of bead breaker, see Fig. 19 and
proceed as shown on previous point 1 and 3.
Publicité
Table des Matières
