Table des Matières
Publicité
10
CHAPTER 3 – INSTALLATION
3.1 SPACE REQUIRED
When choosing the place of installation be
sure that it complies with current safety at
work regulations.
· The tire changer must be connected to the main electric power
supply and the compressed air system. It is therefore advisable to in-
stall the machine near these power sources.
· The place of installation must also provide at least the space shown
in pictures 4 - 4/A so as to allow all parts of the machine to operate
correctly and without any restriction.
· If the machine is installed outside it must be protected by a lean-to.
The tire changer with electric motor cannot
be used in explosive atmospheres, unless it
is a proper version.
Publicité
Table des Matières
