Table des Matières
Publicité
16
3.5 TURNTABLE LOCKING VALUE ADJUSTING
The tire changer turntable is preset by the manufacturer on a middle
range measure from11" to 21" ext. (considering the rim outer side and)
from 13" – 23" int. (if you lock the rim from inner side).
It is however possible to change this dimension range in case of need
when working on larger or small rims; it is enough to change the posi-
tion of the 4 clamps are shown in the figures below.
The obtainable value starts from a minimum of 10"-20" ext. and 12"-22"
int. until a maximum of 12"- 22" ext. and 14"-24" int.
To change the position, proceed as follows:
· Unscrew screw (1) by means of the Allen wrench.
· Remove the locking clamp (2) and the slide piece (3).
· Align the slide hole with one of the guide holes (4) according to the
locking dimensions you want to set. Use the measures below for refe-
rence.
It is important to perform the above men-
tioned operation for all the 4 clamps to
avoid any unbalance in locking phase.
Publicité
Table des Matières
