Table des Matières
Publicité
20
4.2 REMOVING THE TIRE
Before any operation make sure to remove
the old wheel balancing weights and check
that the tire is deflated.
During arm tilting make sure that no-
body stats behind the tire changer.
· Spread the supplied grease (or grease of a similar type) onto the tire bead.
Failure to use the grease could cause
serious damage to the tire bead.
During rim locking MEVER keep your
hands under the tire. For a correct locking
operation set the tire exactly in the middle
of turntable.
OUTER LOCKING
INNER LOCKING
· Position the clamps (G) according to
· Position the clamps (G) so
the reference mark on the turntable
(Y) by pressing pedal (V) down to its
intermediate position.
· Place the tire on the
· Place the tire on the clamps and ke-
eping he rim pressed down, press
the pedal (V) as far as it will go.
Make sure that the rim is firmly fixed to the
clamps.
Never keep your hands onto the wheel: the
arm recovery to "working position" could
set the operator at risk of hand crushing
between rim and mounting head.
.
that they are completely
closed.
clamps and press thepedal
(V) to open the clamps and
thereby lock the rim.
Publicité
Table des Matières
