Storing And Loading A Signal Configuration (Mems) - Promax RP-250 Manuel

USER'S MANUAL. RP-250
When a pilot signal is deactivated it appears indicated on display with a soft
solid colour.

4.2.2.3 Storing and loading a signal configuration (MEMS)

By means of MEMS function it is possible to save and load from the instrument
internal memory the work configurations defined by users.
Each memory registry stores all the parameters corresponding to the pilot signal
configuration: pilots total number, activated or deactivated frequencies and levels.
When pressing MEMS [F4] key appears a display like the one in the following
figure. In the left part is indicated the stored configurations list (whenever they have
been stored through the SAVE option).
Within the lower selection frame appear the functions that can be used with this
configuration: SAVE [F1], DEL [F2] or LOAD [F3].
In order to load a configuration previously stored in the memory, press the
navigation buttons [7] until placing the selection arrow over the memory position to load
and later press the LOAD [F3] option. The RP-250 will adopt the pilot signal settings
previously stored in the memory.
Page 19
Figure 10.- Configuration memories.
03-2007