Configuration Of Internal Parameters (Config) - Promax RP-250 Manuel

4.2.1 Configuration of internal parameters (CONFIG)

Press the direct access
operating function (FREQ, LEVEL, MEMS, PILOT, etc,) and later in order to access to
the configuration menu of the instrument internal parameters press the CONFIG [F1]
option in the lower selection frame.
The following page of options composes the configuration menu for the
instrument internal parameters.
Figure 4. - Configuration of internal parameters (CONFIG).
In order to modify the status of a parameter, press the navigation buttons [7]
until the arrow marks it. Then, activate it by pressing the selection button [8]. The
navigation buttons [7] can be used to modify the value between the available options.
Finally, validate this new value; by pressing the selection button [8] again.
The internal parameter configuration page allows to set the following
parameters:
a) TIME
To change the time, select the TIME field and enter the time using the alphanumeric
keypad. First, the hour field is modified. Later, press the
minutes. Laster, press the selection button [8] to confirm the new time.
b) DATE
To modify the date select the DATE field. First, the day field is modified. Next press
the [10], key. Enter the month and lastly, the year.
03-2007
key [13] to access to the main menu from any
USER'S MANUAL. RP-250
[10]. key to enter the
Page 14