Graf KLARO Easy Notice D'installation page 38

5.6 Outlet pipe
Outlet pipe without sampler
When assembling the Outlet pipe, there are two options: with or without optional sampler.
5.6.1 Outlet pipe without sampler
The SBR reactor outlet pipe is pushed through the special gasket from the inside (socket located internal-
ly). A 90° DN 100 bend is placed in the socket and fixed to the crossbar.
5.6.2 Outlet pipe with sampler
An 8 mm hole is required in the sampler in order to fasten the internal sampler.
The sampler is then positioned in the middle of the tank in the outlet direction, as shown in the image
above, and fixed to the crossbar using nuts and screws. The connection between the sampler and the
socket is fixed using M3x16 Spax screws.
5. Installation of the setting-up kit
Tank size
2,700L
3,750L
4,800L
6,500L
M8x35
36 / 92
Outlet pipe with sampler
H
150 mm
130 mm
120 mm
70 mm