Snap-On EEWH311A Instructions D'opération page 8

®
Tires and rims that are not the same diameter are mismatched.
• • • • •
NEVER attempt to mount or inflate any tire and rim that are mismatched.
• • • • •
ALWAYS check to see that tire and rim diameters are the same.
A mismatched tire and rim could explode causing death or serious personal injury.
Over-pressurized tires can explode causing flying debris.
• • • • •
Read and understand Operator's Manual before operating.
• • • • •
Keep bystanders away from work area.
• • • • •
ALWAYS wear Safety Goggles.
• • • • •
ALWAYS check to see that tire and rim diameters are the same.
• • • • •
NEVER attempt to mount or inflate any tire and rim with different diameters.
• • • • •
Inspect tires. NEVER inflate tires that are damaged, rotten or worn.
• • • • •
NEVER inflate 'Split Rim Wheels' on this tire changer or remove them and use only
an approved safety inflation cage designed for this purpose.
• • • • •
Lock turntable clamp on inside of rim before attempting to inflate tire.
• • • • •
Use approved tire bead lubricant before removing or installing tire on rim.
• • • • •
ALWAYS position the "Safety Restraint Arm" over the wheel to hold it to the
turntable while inflating if so equipped.
• • • • •
If a tire explodes on this tire changer, STOP using it until the "Safety Restraint
Arm" has been replaced, which must be done even if no damage is seen.
• • • • •
NEVER place head or body over a tire during inflation process.
• • • • •
Use short bursts of air to seat tire beads. Check tire air pressure
frequently. NEVER exceed tire manufacturer's pressure limits.
• • • • •
NEVER attempt to bypass or alter the built-in air pressure limiter. Only inflate tire
with air hose supplied with tire changer. NEVER use shop inflation hose to inflate a
tire.
• • • • •
Tire Changer must be anchored to concrete floor if equipped with a "Safety
Restraint Arm".
Exploding tires can cause serious injury.
Page 8
EEWH311A Tire Changer Operation Manual
Operation Manual