POOL squad Ampero Notice D'utilisation page 42

IMMEDIATE AUTOMATIC
MESSAGE
DISPLAYED /
FAULT
Production pH regulation
DETECTED
Yes
Yes
No
No
STOP
POSSIBLE CAUSE
Free chlorine rate out of
tolerance (excess of ± 2
No
ppm compared to the CL
Salt level less than 2.5
g/L (or 1.5 g/L if Low Salt
No
Insufficient quantity of
pH probe incorrectly
No
Electrolyte gel of the
amperometric probe
absent or expired
No
setpoint)
equipment)
water
Carry out a calibration of
calibrated the pH probe.
Fill
electrolyte gel.
Non-memorised Memorise
electrolytic gel refill/change
refill/change electrolyte gel.
CHECKS
AND REMEDIES
Carry out :
- an electrolysis test.
- an adjustment of the
free chlorine rate
measurement.
Check (and adjust if
necessary) the setting
of the CL setpoint.
Set the production
setpoint to 100 %.
Check the salt level
manually with a recent
test kit.
Top up with salt if
necessary, so as to
obtain a salt level of 5
kg/m 3 (or 2.5 kg/m 3
for Low Salt
equipment).
Check that :
- the filtration pump is
working correctly.
- the pipe at the level
of the salt sensor is
completely filled
with water.
Top up the water if
necessary.
up/change the
the last
of
OPTION TO
DEACTIVATE
VIA THE MENU
«
»
Yes
Yes
Yes
Yes
20