Specification Of The Concentration Of The Ph Corrector; Selecting The Chlorinator Operating Mode; Memorisation Of The Last Refill/Change Of Electrolyte Gel; Programming The « Info Gel Cl » Alert - POOL squad Ampero Notice D'utilisation

2.6.6. Specification of the concentration of the pH corrector

Menu

2.6.7. Selecting the chlorinator operating mode

Possible
Menu
settings
Depending on the setting carried out, some menus may not appear.

2.6.8. Memorisation of the last refill/change of electrolyte gel

The electrolyte gel relates to the amperometric probe (see the manual supplied with the probe).
The menu below only appears if the operating mode of the chlorinator is set to "CL".
Menu Sub-menu
2.6.9. Programming the « Info Gel CL » alert
The « Info Gel CL » alert is a reminder to fill/change the electrolytic gel on the same day this alert is activated.
The menu below only appears if the operating mode of the chlorinator is set to "CL".
Menu Sub-menu
2.6.10. Setting the « CL regulation » alarm
The « CL regulation » alarm is triggered when the free chlorine level is out of tolerance (± 2 ppm exceeded from
the CL setpoint).
The menu below only appears if the operating mode of the chlorinator is set to "CL".
Menu
From 12 to 96 hrs, in increments of 12 hrs
Possible settings
From 5 to 55 %, in steps of 1 %
Production
amperometric probe, according to
CL
the CL setpoint and the production
setpoint
Continual
%
production setpoint
OFF Deactivation of the electrolytic cell
Principle
Date of last refill/change
=
Date of last confirmation
Activation delay after the last refill/change of electrolyte gel
Possible settings
From 30 to 180 days, in 30-day increments
Possible settings
Meaning
control with the
production, at the
the message «
Activation delay after fault detection
Default setting
37 %
Indicator viewable
on the display by default
or
(on the display by default)
Confirmation
Press twice on OK :
Default setting
90 days
Default setting
48 hrs
Default
setting
CL
» is displayed.
9