Setting The Production Setpoint; Setting The Ph Setpoint; Setting The Cl Setpoint; Boost Mode - POOL squad Ampero Notice D'utilisation

2.6.17. Setting the production setpoint

Electrolytic cell
operating mode
CL
% Default display

2.6.18. Setting the pH setpoint

Menu

2.6.19. Setting the CL setpoint

The menu below only appears if the operating mode of the chlorinator is set to "CL".
Menu
From 0.1 to 5 ppm, in increments of 0.1 ppm

2.6.20. Boost mode

Boost mode :
- can be used when chlorine is urgently needed.
- sets the production setpoint up to 125 %, for a fixed period.
- can be manually stopped at any time.
I
Boost mode cannot replace a conventional shock treatment in cases of water not fit for bathing.
It is impossible to start Boost mode if :
- An alarm has been activated. (After having resolved and dismissed this alarm, wait a few moments in order to be
able to activate the Boost mode.)
- The operating mode of the electrolytic cell is set to "OFF".
If the Boost mode is restarted manually while it is already running, the Boost mode resets for the duration displayed.
Boost mode continues after powering off the electronics unit.
When the Boost mode is manually terminated or stopped, production continues according to the initial setpoint.
Operation with a cover sensor :
It is impossible to start Boost mode when the cover is closed.
If the cover closes with Boost mode activated, Boost mode stops instantly.
Menu Possible settings
Menu Specific instructions
Directly select a value using
the
confirmation required)
Possible settings
From 6.8 to 7.6, in increments of 0.1
Possible settings
Default setting
12 hrs
24 hrs
24 hrs
- From 10 to 100 %, in steps of 1 %
buttons (no
then from 10 to 100 %,
Switching on
Automatic, as soon as the selected
setting is confirmed, with a delay of
a few moments
Possible settings
OFF (i.e. 0 %),
in increments of 1 %
Default setting
7.2
Default setting
1 ppm
Default
setting
100 %
Switching off
Press on
12