Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.6.12. Calibration of the water temperature measurement
If the temperature sensor is disabled, the menu below does not appear.
Menu
From - to + 5°C compared to the value displayed, in increments of 0.5°C
2.6.13. Calibration of the salt rate measurement
If the salt sensor is disabled, the menu below does not appear.
Menu
2.6.14. Calibration of the pH measurement
Menu
2.6.15. Calibration of the free chlorine rate measurement
The menu below only appears if the operating mode of the chlorinator is set to "CL".
Menu
2.6.16. Adjustment of the current inversion supplying power to the cell
I
The power supply inversion aims to prevent scale deposits on the cell. It is imperative to correctly adjust
this inversion, in order to maintain the good functioning of the cell in the long term.
Menu
Inversion time
Water hardness
Auto : The inversion time is set automatically according to predefined parameters, including the specified water hardness.
Manual : The inversion time is set manually according to the specified value.
Inversion time : This parameter does not appear if the Mode is set to Auto.
Water hardness : This parameter does not appear if the Mode is set to Manual.
Water hardness (°f)
Inversion time (h)
Possible settings
Possible settings
From 0.1 to 8 g/L, in increments of 0.1 g/L
Possible settings
From 6.5 to 7.5, in increments of 0.1
Possible settings
From 0.1 to 5 ppm, in increments of 0.1 ppm
Setting
Possible settings
Auto
Mode
Manual
From 2 to 24 hrs,
in 1 hr increments
Mixed (from 15 to 25°f)
Soft (from 0 to 15°f)
Hard (above 25°f)
0 to 5
5 to 12
16
10
Setting to be determined
According to the description below
According to the table below
According to actual value
12 to 20
20 to 40
8
6
Default setting
Current measurement
Default setting
Current measurement
Default setting
7
Default setting
Current measurement
Default setting
Auto
6 hrs
Mixed
40 to 60
> 60
4
2
11
Publicité
Chapitres
Table des Matières
