Sensor Settings - POOL squad Ampero Notice D'utilisation

2.6.11. Sensor settings

Menu Sensor
Cover/Ext cmd
Flow/pH container
Temperature
Cmd ext : external command.
PH container : empty container sensor.
Type : this parameter does not appear if the corresponding mode is set to OFF.
ON : sensor activated.
OFF : sensor disabled.
NO : switch normally open.
NC : switch normally closed.
Sensor activated
Shutter
External command
Flow
Empty container
Salt
Temperature
Setting
Mode
Type
Mode
Type
Salt
Configuration
Open cover
Closed cover
Command activated
Command not activated
Sufficient flow
Zero flow
Empty container
Container not empty
Salt level less than 2.5 g/L
(or 1.5 g/L if Low Salt equipment)
Salt level equal to or greater than 2.5 g/L
(or 1.5 g/L if Low Salt equipment)
Water temperature below 15°C
Water temperature equal to or higher than 15°C
* To modify this value, contact a professional.
Possible settings
-
-
Cover
OFF
Cmd ext
NO
NC
OFF
pH container
Flow
NO
NC
ON
OFF
ON
OFF
Specific
Production
display
- Maintained
Divided by 5*
- Maintained
Stopped
- Maintained
Stopped
Maintained
- Maintained
Stopped
- Maintained
Stopped
- Maintained
Default setting
Cover
NO
OFF
NO
ON
ON
pH
regulation
Maintained
Stopped
Maintained
10