Publicité
Les langues disponibles
Les langues disponibles
Safety advice for maintenance
Maintenance work must be carried out with the work
vehicle on flat, compact ground, with the tractor en-
gine off, parking brake engaged, and ignition key re-
moved, and adopting all the necessary safety meas-
ures required to work safely.
Any maintenance operations that can be carried out
on the business premises come under the ordinary
maintenance envisaged in the instruction manual.
Maintenance interval schedule
To guarantee constant, efficient and safe machine op-
eration, ensure all the maintenance envisaged by the
Maintenance schedule
Frequency
Component
Dispenser
Every hour
Ploughshare
Lift frame
Every day
Guards
Warning and hazard plates
Machine components
Every 50 hours
Nuts and bolts
Every 150 hours Tyres
Tyre check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check of nuts and bolts tightening torque
Check the tightening torque of all nuts and bolts.
If bolts are loose, tighten them according to the correct
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
English language
MAINTENANCE INFORMATION
Special maintenance operations (non included in
this handbook) require a specialised workshop on
the premises which meets the requirements speci-
fied by the relative laws in force (appropriate equip-
ment suitably trained staff etc.); if you do not have a
compliant workshop, contact an authorised one.
manufacturer is carried out.
Maintenance intervals
Type of work
Cleaning
Cleaning
Integrity check
Integrity check
Inspection
Greasing
Tightening
Pressure check
Check and if necessary restore the tyre pressure (see the
"Technical characteristics" table).
torque values (see "Nuts and bolts tightening torque ta-
ble").
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
35
Manual reference
Guards
Information and safety signs
Lubrication diagram
Check of nuts and bolts tightening torque
Tyre check
7
Use and maintenance
Publicité
