Connecting Data; Guarantee And Liability - Grammer AVENTO PRO M 630 2P Mode D'emploi

Safety instructions
The driver's seat is not watertight and must be protected against splashes of water!

Any conversion or refitting work on a GRAMMER AG driver's seat must be performed

exclusively in authorized workshops by trained or suitably qualified personnel and in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
Improper installation and assembly bear the risk of bodily injury or property damage

and the proper function of the driver's seat or mounted parts can no longer be
guaranteed.
The driver's seat is free of maintenance. Worn parts such as rollers, shock absorbers

and the fixation must be checked from time to time.
Before driving, you must check if all seat settings selected guarantee a safe operation

of the vehicle.
Seat tested and approved in accordance with GRAMMER standard (GN 009, GN 010, GN

011, depending on development date) from 50 kg to 130 kg.

Connecting data

If you need to connect cables to the vehicle supply network, strictly observe the following

instructions:
Before you connect an electrical consumer fitted in the driver's seat (e. g. the seat
heater or the seat ventilation), you must obtain the relevant electrical data for the
respective vehicle with reference to voltage, protection and the kind of connections from
the manufacturer, from GRAMMER AG or the company's agencies.
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
12V DC 10A
24V DC 7,5A
48V DC
Notes concerning seat switch: Minimum and maximum current carrying capacity for
purely resistive load.
In case of inductive or capacitive load, the manufacturer must install a protective circuit
breaker for the consumers in the vehicle. If there are any uncertainties, please ask the
vehicle manufacturer before making connections.
For building an electric connection, select an electric circuit by means of which the electric
consumers of the driver's seat are separated from the live network when the ignition is
switched off.

Guarantee and liability

GRAMMER AG does not disclaim any guarantee or liability for damage resulting from

incorrect assembly, use or repair of the seats.
20
Seat switch – Current carrying capacity
5A
12V DC 10mA (min.)