Chapter 3. Start-Up. Adjustment And Operation Controls - gala gar KENNEDY 200 SYNER Manuel Technique D'instructions

3. START-UP. ADJUSTMENT AND OPERATION CONTROLS.
3.1 OPERATION CONTROLS.
The equipment can be started up once the electrical supply installation has been carried out.
describes the control and regulation system of the KENNEDY SYNER 200 / 160 equipment.
1- Potentiometer: Controls the welding current value
2- : Electrode welding mode.
3- SYN : MMA synergy mode.
4- : TIG welding mode.
5-
6- A: Welding current status indicator.
7- : MMA process arc adjustment indicator.
8- : HOT START setting indicator of the MMA process.
9-
10-
11- Welding mode: Select the welding process.
12- Electrode Selection: When the SYN indicator is on, the electrode diameter can be selected.
13- Function mode: When the indicator
14- +: Positive pole welding voltage connector.
15- -: Negative pole welding voltage connector.
16- Power supply cable.
17- Switch: ON / OFF.
18- Fan.
19- Handle.
Switching VRD on and off: It is activated by simultaneously pressing the buttons for welding mode and electrode
selection.
Activate and deactivate Anti-sticking: is activated by default, to deactivate or activate it the buttons, electrode selection
and function mode must be pressed simultaneously.
KENNEDY 200 / 160 SYNER
KENNEDY 200 SYNER Control panel.
: Electrode diameter selection indicator.
: Graphic welding current indicator.
Digital LED display.
is on, it sets the MMA functions.
12
This section