Chapter 3. Start-Up. Adjustment And Operation Controls - gala gar GALA TECH 2000 G.E Manuel Technique D'instructions

3. START-UP. ADJUSTMENT AND OPERATION CONTROLS.
3.1 OPERATION CONTROLS.
The equiment can be started up once the electrical supply installation has been carried out. This section
describes the control and regulation system of the GALA TECH 2000 G.E. equipment.
D1
Mark Symbol
B ON
C
D1 I
2
D2 (A)
E
+
F
-
G
GALA TECH 2000 G.E.
GALA TECH 2000 G.E. Control panel.
B
E
D2
C
F
G
Description of use.
Green luminous diode. Start-up indicator, "ON"
WELDING PROCESS SELECTOR:
ELECTRODE MODE. In this mode, the HOT START, ARC FORCE, and ANTI-STICKING
functions will be available. Electrode welding is easier and more effective using these.
WELDING PROCESS SELECTOR:
TIG MODE. This work mode is ideal for TIG welding. It allows striking while establishing
low currents when the electrode touches the piece (LIFT ARC), thus avoiding contamination of
the piece and the electrode. The electrode anti-sticking system, as well as arc force and hot
start are nullified.
Control potentiometer of the welding current value.
Dial indicator welding current
Amber coloured luminous diode. Indicating thermal disconnection due to overheating.
Positive pole connector for the welding voltage.
Negative pole connector for the welding voltage.
GALA TECH 2000 G.E.
A- ON/OFF switch.
Situated on the rear of the equipment.
"ON". "ON" "ON"
12
A