Ventilation Speed; Timer; Alarm Testimony "Full Tank; Sleep" Command - Oceanic OCEACLIM900W9 Guide D'utilisation

4. VENTILATION SPEED:

The speed can only be adjusted in Air conditioning and Ventilation mode.
The buttons on the control panel or on the remote control can be used to select the
desired speed by successive presses (Point 6):
F1 = slow speed

F2 = fast speed


5. TIMER:

To set the timer, press the button
control. Pressing the "+" or "-" buttons increases or decreases the time by one hour. (1 hour
at a time).
a) PROGRAMMING THE AUTOMATIC STOP OF THE DEVICE:
- When the device is turned on, press the button.
Select the number of hours you want the unit to operate in CLIMATE mode. The unit will
-
stop automatically once the set time has elapsed.
b) PROGRAMMING THE AUTOMATIC START-UP:
When the unit is in standby, press the button
-
unit in CLIMATE mode.
If the timer is programmed (even when the unit is off), the display shows the number of
-
hours remaining before the unit turns on automatically.

6. ALARM TESTIMONY "FULL TANK":

The Alarm light indicates that the water tank inside the unit must be drained. The
appliance will not operate until the water has been drained (see Cleaning and care
chapter).

7. "SLEEP" COMMAND

To activate sleep mode while the unit is in Air Conditioning mode, press the " Sleep " button
on the center panel or remote control. The fan speed will automatically be set to the lowest
speed. The temperature will increase by 1
after the 2nd hour. This temperature will be maintained during the hours of operation of the
device.
Note :
The " Sleep " mode setting is only available in cooling mode.
on the control panel of the unit or on the remote
. The timer indicator lights up.
to program an automatic start of the
C after the first hour of operation, then by 1
o
47
C
o