Hayward ColorLogic 80 Manuel Du Propriétaire page 9

Each driver is packaged with a power pigtail, two lever connectors (used to connect to transformer),
a large ferrite bead and five sets of strain relief parts. Each light includes a small ferrite bead and
a light connector (used to connect to the driver).
Connecting the Light to the Driver
To connect a light to the driver, cut the light cord to the desired length. Strip the outer jacket back
3" and then strip 6mm off of each conductor. Thread the cord through the strain relief and wrap the
conductors around a small ferrite as shown below. Match the conductor color to the color codes
marked on the connector. With the levers up (open), insert the stripped ends firmly into the connector
and then close down on the lever.
Transformer Connection
Strip back the transformer cable 7" and route the 2 conductors around the large ferrite bead as
shown. Use the two included lever connectors to connect the conductors to the power pigtail as
shown.
Observe
color codes
marked on
the connector
1. Strip cable jacket back 3" (7.5cm)
2. Strip wires to .25" (6mm) length
3. Route wires around Ferrite
4. Open levers on light connector
5. Insert wires (observe color)
6. Close levers
Light Cord
Junction Box Light Driver
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Refer to guide
on label
Strain relief
Strip transformer
cable jacket back 7"
(17.5cm), route wires
around ferrite and
connect to the power
pigtail using supplied
lever connectors
Ferrite
Beads
Insert the
power pigtail
connector into
the socket
located here
After all wiring is com-
plete, slide the board
assembly into light driver
enclosure
Low Voltage Cable from
Transformer (use 14v tap
if available)
8