Introduction - Hayward ColorLogic 80 Manuel Du Propriétaire

Congratulations on your purchase of a Hayward
Your Hayward ColorLogic lights have these special features:
1. Long-lasting LED's (light-emitting diodes) which can last up to 10 times longer than current
incandescent or halogen pool and spa lights.
2. Multi color capability without any color wheels or moving parts to wear out.
3. Multi color program capability which allows you to select any one of 17 different programs, 10
fixed colors, and 7 color shows in stand-alone mode.
4. Offers spectacular brilliant light with low power consumption. Uses up to 86% less energy than
a typical incandescent pool light.
The 12 volt Hayward ColorLogic ½" LED (light-emitting diode) lighting system you have purchased
is UL Listed and intended for use both in and out of water. Because of the all plastic design with an
impact resistant lens, these lights can be installed in and around the pool. They can also be installed
in an upward facing manner without a rock guard for pools, spas, lighting ponds, fountains, or water
falls.
Refer below for specific information about your ½" LED light model.
Two Levels of Brightness
80 Models
LMCUS11050 - high brightness (25% brightness of ColorLogic 320)
40 Models
LNCUS11050 - normal brightness (50% brightness of ColorLogic 80)
GIVE THESE INSTRUCTIONS TO POOL/SPA
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Introduction

ColorLogic
®
OWNER AFTER INSTALLATION
½" LED light.
®
2