Installation - Hayward ColorLogic 80 Manuel Du Propriétaire

Before You Begin
Both the LMCUS11050 and the LNCUS11050 lights must be used with a LMCUSPS005 junction box
driver. Do not attempt to power the lights directly to a power supply. The LMCUSPS005 junction box
driver require low voltage (12 volt) power only. Do not connect high voltage to the junction box driver.
Cord Length and Minimum Required Voltage
When installing ColorLogic ½" LED low voltage system, the length of the power input cord has an
effect on performance. To prevent performance problems, verify the transformer is providing the
minimum required voltage according to the table below. To check this voltage, measure the voltage
at the transformer while the light is "on" and operating in "white" mode. In some cases, a voltage
greater than 12 volts is required due to a long cord run. Some transformers provide higher voltage
taps for this purpose; check your transformer manufacturer's installation instructions for details.
When using Hayward or other transformers that offer a 14v option, we suggest that you always use
the 14 volt tap.
NOTE: Environmental conditions and long cord lengths (over 100') could cause a voltage drop that
may result in decreased brightness.
Product
12v
ColorLogic
80/40
3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Installation

Total Cord Length
from Transformer
to Junction Box
Driver
30 ft
50 ft
100 ft
Minimum Required
Voltage at
Transformer
12 - 14 volts
13 - 14 volts
14 volts