Operation - Hayward ColorLogic 80 Manuel Du Propriétaire

Wiring Multiple Drivers
Driver 2
To additional Drivers
Driver 1
To Hayward 80/40
Accent Light (5)
To Hayward 80/40
Accent Light (5)

Operation

Operating the 1/2" LED Lights
The ColorLogic light is controlled through power-cycling: a method of changing light programs which
requires no special interface. To activate the light, simply turn on the switch powering the trans-
former. To deactivate the light, turn off the switch. To advance to the next light program (fixed color
or color show), turn the switch off, then back on again within 10 seconds.
When the lights have been off for over 60 seconds, and are first turned on, they will come on to
white for 15 seconds for quick clear view of your pool, then go to the last fixed color or color show
that was running.
Light Synchronization
If your pool or spa has multiple Hayward ColorLogic LED lights, they may be operated independently,
or they can be easily synchronized so they will all display the same colors and shows at the same
time. For light synchronization, all lights must be wired to the same switch. Once installed, all lights
should be automatically synchronized, however, if they get out of sync, they can be re-synchronized
easily.
To re-synchronize your lights, start with the lights off and follow the steps below:
1. Turn lights on.
2. Turn off light for between 11-15 seconds,.
3. Turn lights on.
When the lights come on, they should enter program #1 (Voodoo Lounge), and be synchronized.
9
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS