Hayward ColorLogic 80 Manuel Du Propriétaire page 6

Vertical or Horizontal Landscape Installations
When running Schedule 40 PVC conduit for landscape applications, use fittings, elbows, etc. to posi-
tion the light in the desired location. Snake the light cord through the optional supplied endcap and
conduit. The conduit can be angle cut and notched as shown below to help prevent pinching the
exiting cord. For vertical installations, drive a portion of rebar or equivalent material into the ground
to create the hole for the conduit.
Optional endcap
1/2" Conduit
Cut notch to prevent
pinching cable
Securing lights
With the ½" PVC conduit secure in the pool or landscape wall, follow these steps to secure the light:
1) Run the ColorLogic ½" LED light cord through the optional endcap and conduit to the light
driver.
2) After wetting or lubricating the LED light's O-ring, insert the light fully into the conduit. Press
firmly until the light sits flush with the wall.
1
LED light
2
3
Insert LED light until firmly seated
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Route cord through PVC conduit and back to light driver
Wet or lubricate O-Ring before inserting LED light into
PVC conduit
2.5" min
At least 2.5" of straight pipe is required
to create a proper seal.
Coupler
If using flexible pipe, add 2.5"
Flex pipe
of straight ½" rigid conduit.
½" PVC Conduit
To light driver