Electromagnetic Interferences And Electromagnetic Compatibility Tables - I-Tech MIO-CARE TENS Notice D'utilisation

In order to preserve the warranty, the functionality and the security and safety of
the product, it is highly recommended to use exclusively the spare parts given by
the manufacturer (see also paragraph Warnings).
Electromagnetic interferences and electromagnetic compatibility
tables
The MIO-CARE equipment has been designed and manufactured according to the
international ELECTROMAGNETIC COMPATIBILITY legislation EN 60601-1-2:2015
with the aim of providing adequate protection from harmful interference when
installed in homes and health establishments.
The equipment does not generate significant radio frequency energy and is
adequately immune to radiated electromagnetic fields. Therefore, it does not
detrimentally interfere with radio-electric communications, electro-medical
equipment for monitoring, diagnosis, therapy and surgery, office electronic
devices such as computers, printers, photocopiers, fax machines, etc. or any
electric or electronic equipment used in these environments, as long as the
equipment complies with the ELECTROMAGNETIC COMPATIBILITY directive.
In general, the use of accessories other than those specified or provided by the
manufacturer could result in increased electromagnetic emissions or decreased
electromagnetic immunity of the MIO-CARE and result in improper functioning.
In any case, in order to avoid any interference problems, it is recommended to
use the therapy equipment enough far away from critical equipment for
monitoring vital patient functions, and to be careful when applying therapy to
patients with pacemakers. In any case it is recommended to use the equipment
at least at 3 meters away from televisions, monitors, cellphones or any other
electronic equipment, in particular portable RF communications equipment
(including peripherals such as antenna cables and external antennas) should not
be used closer than 30cm (12 inches) to any part of the device, including the
cables specified by the manufacturer; otherwise, it could lead to degradation of
the performance of the MIO-CARE.
In conclusion, the use of MIO-CARE adjacent to or stacked with other equipment
should be avoided, since it could cause improper functioning. If such use is
necessary, the MIO-CARE and the other equipment should be constantly
observed to verify that they are operating normally.
When MIO-CARE is used in an environment relatively dry, strong electromagnetic
interferences usually occur. At this time, the device may be affected as follows:
the device stops supplying;
-
the device turns off;
-
the device restarts.
-
IACER Srl 115 MNPG95-05