Tools Needed For Assembly - skilsaw SPT70WT Consignes D'utilisation/De Sécurité

2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 9
Tools Needed for Assembly and Adjustment
Disconnect plug from power source before performing any assembly, adjust-
ment or repair to avoid possible injury.
WARNING
Phillips & Flat Head
Screwdriver
Blade Wrench
(supplied)
1. Position square and
draw a light line
3/4" board with
straight top edge
10 MM Wrench
2 MM Hex "L" Wrench
(supplied)
COMBINATION SQUARE MUST BE TRUE
drawn line no gap or overlap
-9-
Combination Square
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.