Lubrication - skilsaw SPT70WT Consignes D'utilisation/De Sécurité

2610039875 12-15 E_SPT70WT 12/23/15 10:55 PM Page 37
Make sure the teeth of the ANTIKICKBACK pawls
are al ways sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward rear of spreader so that
teeth are above top of spreader.
3. Hold spreader with pawl over corner of work-
bench (Fig. 65).
4. Using a small round file (Smooth Cut) sharpen
the teeth.
All repairs, electrical or me-
chanical, should be attempted
only by trained repairmen. Contact the nearest
WARNING
Factory Service Center or Authorized Service Sta-
tion or other competent repair service. Use only
identical replacement parts, any other may create
a hazard.

LUBRICATION

The gear case has been completely lubricated at
the factory. However, after six months to one year,
depending upon use, it's wise to return your tool
to the nearest Service Center for the following:
• Brushes replaced.
• Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 oil, or WD 40 (Fig. 66).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
FIG. 66
-37-
FIG. 65