Assembly; Unpacking And Checking Contents; Tools Needed For Assembly And Alignment - skilsaw SPT88 Consignes De Fonctionnement/Sécurité

UNPACKING AND CHECKING CONTENTS

WARNING
cord or turn the switch on until the missing
parts are obtained and are installed correctly.
CAUTION
into the 50° left or 60° right position. Lock the
bevel-lock handle. Lock the head assembly in
the down position.
Never carry the tool by the cord or the head-
assembly power switch handle. Damage
to insulation could cause an electric shock.
Damage to wire connections could cause a
fire.
Model SPT88 Compound Slide Miter Saw is
shipped complete, in one box.
Combination Square (not supplied)
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
WARNING
If any parts are missing,
do not plug in the power
Before moving the saw:
Lock the miter-lock knob

TOOLS NEEDED FOR ASSEMBLY AND ALIGNMENT

2 size allen wrench
1/4 inch Hex, T30 Torx (supplied)
Draw Light Line on Board
Along this Edge
Disconnect plug from power source before performing any assembly,
adjustment or repair to avoid possible injury.

ASSEMBLY

1. Separate all parts from Loose Parts list
below to make sure that all items are
accounted for before discarding any
packing material.
2. Loose Parts:
Vertical Clamp - Provides fast clamping
•
of workpiece.
Hex Wrench - Stored behind sliding
•
fence.
Miter-Lock Knob
•
Dust Bag
•
Dust-Chute Elbow
•
2 Crown Stops (left and right)
•
2 Crown-Stop Knobs
•
Operating/Safety Instructions
•
Combination Square Must be True
1/8 Inch Hex Wrench
(not supplied)
Straight Edge of Board 3/4" Thick
This Edge Must be Perfectly
Straight
15