Usage Limits - Deltaplus AN063 Série Notice D'utilisation Et D'entretien

USAGE LIMITS:

Before any PPE implementation operation, set up a rescue plan to deal with any emergency that may occur during the
operation.
Metal products and mechanical products (self retracting fall arrest device, sliding, work on ropes, anchors etc. ...) : Maximum
duration of 20 years from the date of manufacture (including storage and use).
Textile products or those containing textile elements (harnesses, belts, shock absorbers etc...): maximum life of 10 years in
storage (from date of manufacture), 7 years after the first use.
The shelf life is given as an indication. The following factors can cause it to vary greatly:
- Non-compliance with the manufacturer's instructions for transport, storage and use - "Aggressive" work environment: marine
atmosphere, chemicals, extreme temperatures, sharp edges...
- Particularly intensive use - Shock or significant constraint - Disregard for the product item's history
Warning: these factors can cause damage invisible to the naked eye.
Warning: certain extreme conditions can shorten the shelf life by a few days.
If in doubt, always remove the product for it to undergo either: - a review - destruction The shelf life is not a substitute for
periodic verification (minimum annually) which will assess the condition of the product.
TO FIND YOUR LOCAL ANNUAL REVIEW CENTRE, VISIT WWW.DELTAPLUS.EU.
No modification or addition or repair of the PPE may be made without prior written consent from the manufacturer nor without
using their procedures.
Do not use beyond the area of use defined in the instructions for use.
The manufacturer cannot be held liable for any direct or indirect accident after a modification or use other than that provided in
this manual.
Do not use this equipment beyond its limits.
To ensure its working condition and therefore the safety of the user, the product should be checked systematically:
1 / visually inspect the following points:
-State of the strap or rope: no fraying, no boot cut, no visible damage at seams, no burning and no unusual narrowing
- State of the cable: no start of rupture of one or more threads, no folding, no burning, no corrosion or oxidation, no
deformation of the cable stranding.
- Condition of the metal parts: no wear, no deformation, no corrosion or oxidation
- General condition: look for any possible damage due to ultraviolet radiation and other climatic conditions
- Correct operation and locking of connectors
Specific conditions such as humidity, snow, ice, mud, dirt, paint, oil, glue, corrosion, wear of the strap or rope, etc.. can
significantly reduce the operation of the fall arrest device.
2 / in the following cases:
- Before and during use - if in doubt
- In the case of contact with chemicals, solvents or fuels that could affect operation
- If it has been subjected to stress during a previous fall
- At least every twelve months by the manufacturer or a competent organization, mandated by them.
PERIODIC REVIEW of PPE:
An examination should be performed at least every twelve months by the manufacturer or a competent organization,
mandated by them. This very important check is related to the maintenance and efficacy of the PPE and hence the user's
safety. A written document authorising reuse should be obtained during this audit in order to reuse the PPE. This document
will clarify that the user's safety is linked to maintaining the efficiency and resistance of the equipment.
Replace the PPE if necessary.
In accordance with European regulations, the identification form must be completed prior to the first use of the product and
then updated and kept with the product as well as the manual by the user.
The legibility of the product labelling should be checked periodically.
WARNING:
The user's safety depends on the continuing efficacy of the PPE, its strength and the proper understanding of the instructions
in this manual.
7
UPDATE : 03/02/2014