Performing Measurements; Data Management - WIKA GA11 Mode D'emploi

5. Commissioning, operation

5.4 Performing measurements

1. Press "Measurement".
2. Configure the measuring methods and press "Start" to confirm.
⇒
The measurement begins.
Measurement with internal depot
The measuring gas will be stored temporarily in the internal depot and later be pumped back
into the gas compartment to be measured or a pressurised external gas compartment.
Measurement with external container (depressurised)
The measuring gas will be directly pumped into a depressurised external gas compartment
(e.g. gas recovery bag, model GA45).
Pumping back after the measurement
Once the measurement is finished, a selection window will open, which enables the
selection of the storage location.
Multiple measurement
The multiple measurement makes it possible to perform the gas quality check at specific
intervals automatically.
WIKA operating instructions analytic instrument, model GA11
Measurement
Data
management
Settings
17
EN