1.0 INTRODUCTION
1.1 Kit Contents
ALL kit contents must be installed.
•
(1) 52" plenum kit: KZK-052
•
(1) plenum discharge trim: KZK-052DT
•
(12) 6" collars - (6) to attach to the bottom of the plenum; (6) to
attach to the unit where the cover plates are removed
(1) KZK-610 is used for a 10' vent run. If installing beyond 10' vent run,
you will need to order (1) KZK-CPL6.
KZK-CPL6 is (6) 6" couplers that connect (2) KZK-610.
(6) take o collars included
Figure 1.1, #KZK-052
#KZK-610
(6) - 10' x 6" (aluminum ex) listed to UL-181Class 0 Air Duct
Figure 1.2, #KZK-610
Komfort Zone Kit #KZK-052 R.1
#KZK-052
⁄
54
"
(1387mm)
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
1.2 Fireplace Preparation
The header heat shield is not required for KZK-052 installation.
The stand-off assembly still must be installed. To install stand-off
assembly,
1.
Locate the stand-off assembly and header heat shield on top of
the fireplace, as shipped.
2.
Discard header heat shield.
3.
Attach the stand-off assembly pieces as shown below and secure
with (4) screws.
⁄
4
"
(122mm)
Figure 1.3, Stand-off Assembly Installation
Remove and discard header heat
shield for Komfort Zone Kits only
Stand-o assembly
INTRODUCTION 3