1.0 INTRODUCTION
1.1 Kit Contents
ALL kit contents must be installed.
•
(2) 15" plenum kit: KZK-1510
•
(2) air grilles
•
(12) 6" collars - (6) to attach to the bottom of the plenum; (6) to
attach to the unit where the cover plates are removed
(1) KZK-610 (sold separately) is used for a 10' vent run. If installing
beyond 10' vent run, you will need to order (1) KZK-CPL6.
KZK-CPL6 is (6) 6" couplers that connect (2) KZK-610
#KZK-1510
(6) take o collars included
Figure 1.1, #KZK-1510
#KZK-610
(6) - 10' x 6" (aluminum ex) listed to UL-181Class 0 Air Duct
Figure 1.2, #KZK-610
Komfort Zone Kit #KZK-1510 R.5
1.2 Fireplace Preparation
1.2.1 BHM-52 Requirements
The header heat shield is not required for KZK-1510 installation.
The stand-off assembly still must be installed. To install stand-off
assembly,
1.
Locate the stand-off assembly and header heat shield on top of
the fireplace, as shipped.
2.
Discard header heat shield.
3.
Attach the stand-off assembly pieces as shown below and secure
with (4) screws.
Figure 1.3, BHM-52 Stand-off Assembly Installation
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
Remove and discard header heat
shield for Komfort Zone Kits only
Stand-o assembly
3