Disposable Bag & Filter - Cyclo Vac E Serie Manuel D'instructions

Disposable Bag & Filter
(Axess, GS110 & GS111 models)
Change the bag when the one in place is full.
Frequency will depend on the use of the unit.
1. To access bag, remove the power unit top cover.
2. Remove the used bag and seal bag opening
(adhesive seal provided on each bag). Discard
used bag.
3. Install the new bag, ensuring the tabs on the
bag adaptor are aligned with the slots in the bag
collar (figure 19).
4. Ensure adequate sealing by inserting bag as far
as retention ring (figure20 - A).
Rotate bag 20° (figure 20 - B) to ensure tabs
on bag adaptor are no longer aligned with the
slots in the bag collar.
5. Replace top cover.
The disc-shaped filter (figure 21), located between
the dust bag and the motor, should be changed
once for every three bags (45 hours of use), or
more often as needed.
Use only genuine Cyclo Vac replacement bags.
Failure to do so could void the warranty on your
vacuum unit.
Type 3 bag
Part number : TDSAC43C
28
retention ring
Maintenance
figure 19
tabs on bag adaptator
B
A
figure 20
figure 21