Low Voltage Connections - Cyclo Vac E Serie Manuel D'instructions

Connect the low voltage wires to the low voltage inlet on your unit.
To do so:
1. Strip wires over 1 cm (½ inch) (figure 5).
2. Gently press on the toggle to open the connector (figure 6).
3. Insert stripped wire (figure 7).
4. Release toggle to secure wire in connector (figure 8).
5. Repeat for second wire.
To disconnect:
1. Gently press on the toggle to open the connector.
2. Remove low voltage wire from connector.

Low Voltage Connections

figure 5
figure 7
Installation
figure 6
LED
details on
page 19
figure 8
17