Cyclo Vac E Serie Manuel D'instructions page 12

Muffler Installation
5010 - 5011 (1 muffler) & 7010 - 7011 (2 mufflers) MODELS
1. Insert the rubber coupling (A) on the vacuum air exhausts (D).
2. Using a Phillips screwdriver, tighten the clamp collar (A) to ensure adequate
sealing.
3. Insert the 90° elbow (B) into the rubber coupling (A),
and tighten then clamp collar as per instructions in
step 2.
4. Apply ABS glue to the 90° elbow (B) and insert
muffler (C).
Note : if venting exhaust to the outdoors, we
recommend the use of metal
pipes, and the installation of
the muffler 2 feet from the unit.
A
WARNING
least 2 inches (5 cm) in diameter, for a length
of 24 inches (60 cm). Do not connect both
exhausts to the same conduit.
14
7010 - 7011 (2 mufflers) MODELS
Metal pipe
Installation
C
B
A
D