Maintenance; Motor; Carbon Dust Filter - Cyclo Vac E Serie Manuel D'instructions

Motor

Please note that Cyclo Vac motors do not require lubrication. Each motor
contains two carbon brushes which will wear normally, and may eventually require
replacement. For warranty purposes, this should be done by an authorized service
center. Brush life is affected by the number of hours used, frequency of start-ups
and shut-downs, humidity, altitude, and temperature. In order to avoid damage
to the motor itself, brushes should be replaced before they are completely worn
out. We therefore recommend that you have your unit and motors inspected by a
service center every 5-6 years.

Carbon Dust Filter

(Patented)
(Except models Axess - 110, 111 - 210, 211)
We recommend changing this filter after three bag
replacements. For the GX series, the integrated
monitor will indicate when to change the filter.
These indications are provided by an electronic
timing board, only as a reference guide.
To do so:
1. Unlatch the opening on the carbon filter case
and gently flip it upward (figure 10).
2. Remove the used filter, and discard (figure 11).
3. Insert the new filter. When doing so, please
ensure that the arrow printed on the filter itself
points outwards. (figure 12).
4. Close casing opening, and latch.
Part number : TDFILHEC2
24
figure 12

Maintenance

figure 10
figure 11