Masquer les pouces Voir aussi pour E Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Filters

(E & DL Series)
We recommend regular maintenance of the
filtration system, in order to ensure your
central vacuum's maximum performance.
Your Cyclo Vac central vacuum is equipped
with two filters. An anti-clogging filter
(thin fabric) stops the larger particles,
and a Cyclofiltre (thick fabric) catches
the microscopic particles and is treated
with Ultra-Fresh* to prevent the growth of
mold, fungus and bacteria. Both filters are
washable in cold water (no bleach). Dry at low
temperature.
1. To remove the filters, first remove the dust
receptacle (figure 13).
2. Then use the straps at the base of the
filters to withdraw them (figure 14) We
recommend that you clean the anti-clogging
filter (thin fabric) every time you empty the
dust receptacle. You may either shake it
out, or wash it. The Cyclofiltre (thick fabric)
should be cleaned after four anticlogging
filter cleanings, or approximately once a
year.
3. It is important that both filters be
completely dry before they are reinstalled.
They should be carefully installed in the
support grooves (figure 15) on the filter
frame to ensure adequate protection for the
motor. Install the Cyclofiltre (thick fabric)
first, and the anticlogging filter (thin fabric)
over it.
Before replacing the filters, inspect them for
tears or punctures. Do not reinstall damaged
filters.
* Ultra-Fresh est une marque de commerce de Thomson Research Associates.
26
Maintenance
figure 13
figure 14
figure 15
Part numbers :
DL : TDFICY21
E : TDFICY22

Publicité

Table des Matières
loading

Table des Matières