Maintenance And Care; Repair; Accessories - Festo ESBF-BS Notice D'utilisation

ESBF-BS
Fitting in a vertical or sloping position:
Warning
Injury to people and damage to property.
If there is a spindle nut fracture inside the ESBF or
a toothed belt breaks when using parallel kit
EAMM-U (e.g. due to wear), the work mass will fall
down.
• Check whether additional external safety
measures against damage are required
(e.g. toothed latches or moveable bolts).
• Examine the toothed belt of the parallel kit reg-
ularly for wear
( assembly instructions for the parallel kit).
8

Maintenance and care

• When necessary, clean the outside of the ESBF with a soft cloth.
Cleaning agents: all non-abrasive agents.
• Grease the surface of the piston rod 1 when needed or when a
grease layer is no longer noticeable on the component. Use the
following grease:
– Standard type:
– F1 type:
9

Repair

• Recommendation: Send the ESBF to our repair service.
This way, the fine tuning and tests that are required will be taken into particular consideration.
• Information about spare parts and auxiliary means can be found at:
( www.festo.com/spareparts).
10

Accessories

Note
• Please select the appropriate accessories from our catalogue
( www.festo.com/catalogue).
22
LUB-KC1
LUB-E1
Fig. 10
1
Fig. 11
Festo – ESBF-BS – 1201NH English