Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capa-
city higher than 650m³/h, are equipped with a
timer device that automatically switches the suc-
tion speed from 4th to 3rd speed, after 5 minutes
operation.
External motor models are equipped with remote
motors that , as for internal motor versions, inclu-
de a timer device that switches down the suction
speed when it exceeds 650 mᵌ/h. (See External
Motors Instructions ).
Remote motors, whose air capacity exceeds
650m³/h at both 4th and 3rd speed , will have the
following by default timer control functions: The
suction speed is automatically switched from 4th
to 2nd speed, after 6 minutes operation.
If the appliance is working at 3rd speed, it is auto-
matically switched to 2nd speed, after 7 minutes
operation. Operation speeds can also be chan-
ged during operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
Particular care is due to the grease filter.
It can be removed by following the instructions
below:
Open the front glass panel by selecting the ma-
ximum speed, remove the steel grid by pulling it
outwards (fig. 8), then act on the filter handle and
rotate it outwards.
After 30 hour working, the grease filter saturation
will be signaled by the simultaneous lighting of
speed indicators; select the timer function with
the hood off to reset it.
The grease filter needs cleaning by regular hand-
washing or in dishwashers, every two months at
least, or depending on its use.
* If the appliance is used in the filtering version,
the activated charcoal filter needs to be replaced
periodically.
The charcoal filter is removed by removing the
grease filter first, following the instructions above,
then by pulling its special plastic tongue until it is
released from its seat.
The charcoal filter is inserted by following the re-
verse procedure.
Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive
products should be avoided.
The power cord shall be replaced by authori-
zed personnel only.
Substitution of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to fig. 13), disconnect it elec-
tronically using the appropriate connector then
substitute it with a LED bar with same charac-
teristics.
17
Publicité
Table des Matières
