Safety Information; Intended Use; General Safety Instructions - Rothenberger ROSOLAR PUMP Instructions D'utilisation

1

Safety information

This manual provides important information for a safe and correct operation of the solar filling
unit ROSOLAR PUMP and ROSOLAR PUMP PLUS.
The manual is designed for qualified personnel who are trained and specialised in installing
heating systems. Service and maintenance works must only be carried out by approved specialists.
1.1

Intended use

The filling unit is designed/used for filling, flushing and venting thermal solar systems and heat
pump systems. Any other use or extended use is considered to be improper. The manufacturer is
not liable for any resulting damage.
1.2

General safety instructions

Store these instructions in such a way that they are accessible at all times for operating
personnel!
In addition to these operating instructions the following documents of related components and of
the pumping media should be applicated technical specifications , material safety data sheets,
operating instructions.
The manufacturer shall not be held liable for damage resulting from non-adherence to
the operating instructions!
Danger of death due to electric shock!
Prior to work on the pump, always disconnect the drive from the power supply.
Danger of death due to explosion!
Do not pump any liquids with a flash point of less than 55° C . Do not pump petrol or
solvents.
Danger of scald burn due to high media temperature!
Fill the solar system only when cold – if necessary cover the solar collectors.
Danger of burn due to hot motor casing!
Do not block neither suction nor pressure hose more than 1 minute to avoid overheating
of the motor.
Danger of injury due to splashing liquid!
Connect the hoses tightly to the pump.
Material damage due to dry running!
Never allow the pump to run dry for more than 1 minute.
Material damage due to tilting of the cart on uneven ground!
Operate the filling unit only on even ground.
Danger of environmental damage due to hazardous pumped media!
Collect escaping pumped media and dispose of according to the locally applicable
regulations.
Material damage due to improper storage!
Prior to extended periods of pump down time clean pump to avoid adhesions and
damage to the impeller. Store pump under frost-protected conditions!
ENGLISH
9