Operation With Ios; Connect The Screen/Dvr To The Network; Download And Set Up The App - Conrad Electronic Sygonix 1486624 Notice D'emploi

17. Operation with iOS

a) Connect the screen/DVR to the network
• Switch off the screen/DVR and connect it to the docking station.
• Connect the docking station to your network via a 1:1 connected network cable (e.g. router or switch).
• Switch on the screen/DVR.
• Call the network setting menu, see chapter 11. a).
• Configure the settings for your network. Usually, no settings are needed, since the screen/DVR automatically
receives the IP-address (DHCP is pre-set), if your network has a DHCP server (usually integrated in every router).
However, if you have switched off the DHCP server in your network and assigned IP addresses manually for each
device, you need to assign a dedicated IP address to the screen/DVR as well.
You can use any password in the input field for the password that is required in connection with the App.
• Now call the network information in the bottom-most line in the network setting menu. The IP address of the screen/
DVR should be displayed here now, along with a QR code.
If this is not the case, save the settings and leave the setting menu. Switch off the screen/DVR. Wait for a
few seconds and switch on the screen/DVR again.
b) Download and set up the App
• Download the required free App "GoCam4CH" from the Apple Store and install it on your smart-
phone.
At the time these operating instructions were drawn up, at least iOS 6.0 was needed. This may, of
course, change for new versions of the App.
• After starting the App, you can add a new device in the App by either scanning the QR code in the network informa-
tion of the screen/DVR or simply entering the device ID indicated to the left of the QR code.
If you have several screens/DVRs of the same build (or devices that use the same App). You can register
them in the same manner.
• In the password input field of the App, the password must be entered that you have used in the screen/DVR in the
network setting menu; you can also switch off the password function.
• Always also enter a title/name for the device (any name). You cannot complete registration otherwise.
• Depending on the number of present cameras, you can switch the corresponding channels CH1, CH2, CH3 and
CH4 on and off.
• After selecting the device, an empty screen will appear. click the icon "
the available cameras.
If the screen/DVR is in a menu, image transmission will not be possible. Leave the OSD menu on the
screen/DVR so that one or several camera images are displayed (for selection, see chapter 9. e).
If you call the OSD menu the screen/DVR while the video image is displayed on your smartphone, video
transmission will stop and the smartphone will show an error message.
" at the top to display the video image of
83