Function "Power Saving Mode - Conrad Electronic Sygonix 1486624 Notice D'emploi

q) Function "Power saving mode"
Here you can set a time after which the LC display will switch off to save power. Furthermore, whether the LC display
will switch itself on when a movement is recognised in the recording area can be switched on/off.
Only the LC display is switched off; monitoring or recording are not influenced.
• After calling the function, you can select from two settings with the control buttons "
button "OK" (8) to confirm:
"Time interval": Use the arrows "
function can also be switched off; then the LC display remains permanently activated.
"Wake up on motion": The arrows "
when the PIR sensor in a radio camera recognises a motion/heat change in the recording area.
• Save the selection with the button "OK" (8); then you will leave setting mode again. Cancel as usual with the
"MENU" (5) button.
72
" or " " to set a time after which the LC display switches off automatically. This
" or " " can be used to set whether the display is automatically activated
" or " "; briefly push the