Function "Activation; Function "Image Setting - Conrad Electronic Sygonix 1486624 Notice D'emploi

b) Function "Activation"
Missing or unused radio cameras (or channels) can be switched off.
This may also be used to avoid displaying missing radio cameras when selecting the camera image with the button
"QUAD" (6).
• After calling the function, use the control buttons "
• Use the control buttons "
• Save the setting with the button "OK" (8); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (5). The display
will switch back to the prior menu.
c) Function "Image Setting"
Here, you can set resolution and image quality for the screen/DVR when recording the camera image video. The set-
ting can be made separately for each of the four radio cameras (channels).
The higher the resolution or quality, the more memory is needed for the video recording.
• After calling the function, use the control buttons "
• Briefly push the button "OK" (8).
• Use the control buttons "
video quality.
• Use the control buttons "
to the right shows the current setting.
• Push the "MENU" (5) button to accept the settings. Push the "MENU" (5) button again to leave the setting menu.
78
" or " " to switch the selected radio camera on or off.
" or " " to switch between the settings for the resolution and the video compression/
" or " " to select the respective setting; then push the button "OK" (8). A check mark
" or " " to select one of the four radio cameras.
" or " " to select one of the four radio cameras.