Operation; Fastening The Wall Bracket; Usage; Troubleshooting - Conrad Electronic 75 13 76 Mode D'emploi

6.

Operation

Find a suitable place for mounting from which the desired object can be observed. A suitable place for mounting has the following features:
• Dry.
• As free from dust as possible.
• Little vibration.
• Good air circulation.
• There is a mains socket in the proximity.
6.1.

Fastening the wall bracket

Before drilling or fastening screws make sure that there are no electric cables, pipes, or wires running through concrete or masonry that could
be damaged.
Do not point the camera directly toward a source of bright sunlight, as this could lead to over-exposure and an unclear picture.
6.2.

Usage

Reconnect the system as described under point 5 "Test" and operate to start surveillance.
7.

Troubleshooting

With this product, you purchased a reliable product which is designed using current state-of-the-art technology. Nevertheless, problems or failures might occur. In the
following, you will get information on how you can eliminate possible faults.
Strictly observe the safety instructions.
Error Possible cause
•
No image
•
•
The image is distorted
•
Flickering/running/B/W image •
All repairs other than the ones described above must be carried out by authorized specialists (electricians) only.
8.

Maintenance and cleaning

The devices need no maintenance other than being cleaned occasionally. For this reason, you should never open them. If you do open the devices, the warranty will be
rendered invalid. The outside of the devices should be cleaned with a clean, slightly damp cloth or brush only. Do not use cleaning agents which contain carbon, petrol,
alcohol or similar substances for cleaning purposes. Otherwise the appliance covering could corrode. Moreover, the vapours are detrimental to health and are explosive.
Nor should sharp-edged tools such as screwdrivers or metal brushes be used for cleaning purposes.
14
1. Use supplied screws to attach wall bracket to wall or suitable platform.
Use dowels if relevant.
2. Align the camera and screw the T - bolt tight.
Camera is not supplied with electricity.
Check all cable connections.
The range of the system was exceeded. Shorten the distance.
The supply voltage is too low.
Strong spotlight in the cover range of the camera.
9.

Disposal

9.1.

Dispose of waste electrical and electronic equipment

In order to preserve, protect and improve the quality of environment, protect human health and utilise natural resources prudently and rationally, the user
should return unserviceable product to relevant facilities in accordance with statutory regulations.
The crossed-out wheeled bin indicates the product needs to be disposed separately and not as municipal waste.
10.

Technical data

Camera
Operating voltage
Current consumption
Picture sensor
Picture element
Resolution
Video output
Lens
Sensitivity
IR lighting
S/N ratio
Dimensions (L x W x H)
Power adaptor
Operating voltage
Output voltage
12V DC
0,22 W (max.)
1/4CCD colour
510 x 490 (NTSC) 628 x 582 (PAL)
330 TV lines (horizontal)
1 vp-p / 75 Ohm
3.6 mm
2~20 Lux (with infrared LED)
11 x 1 CDS
>48 dB
128 x 72 x 60 mm
230V~ 50Hz
12 V DC / 600 mA
15